Husqvarna BMP 215 Bedienungsanweisung Seite 31

15. BMP 215: Do a check of the direction of rotation of
the motor. An arrow on the housing of the motor
shows the correct direction of the motor. If it is
necessary, change the direction of the motor. Refer
To change the direction of rotation of the motor
to
BMP 215 on page 33 .
To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Connect the dust extractor hose to the connection
for dust extractor. Refer to
215 on page 23 for information about where the
connection for dust extractor is on your product.
To connect the product to a power
source BMP 215
1. Connect the power plug of the product to an
applicable extension cable.
2. Connect the extension cable to a mains outlet.
CAUTION:
connected to a dust extractor, the dust
extractor must be connected to a 3-phase
power source.
To fill fuel BMP 215Petrol
If available, use low-emission/alkylate gasoline. If low-
emission/alkylate gasoline is not available, use good
quality unleaded gasoline or leaded gasoline with octane
number not less than 90.
CAUTION:
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let remaining fuel dry off.
3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
5. Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank before a start.
1819 - 002 - 07.04.2022
Do not use the dust
Product overview BMP
When the product is
Do not use gasoline with an
To start the product
1. Make sure that the lift lever is in up position. Pull the
lift lever up (A) and then out (B) from the handle to
move the scarifying drum up.
B
A
2. Make sure that the depth adjustment wheel is
in up position. Turn the depth adjustment wheel
counterclockwise (A) to move the scarifying drum up.
(B).
A
B
31