Symbols On The Product; Type Plate - Husqvarna CG 200 Bedienungsanweisung

1. Safety lever (operator presence control)
2. Steering shaft
3. Shaft adjustment knob
4. Depth adjustment knob (mm)
5. Quick raise/lower lever
6. Lifting eye
7. Engine / Motor
8. Belt tensioner
9. Chassis
10. Transmission
11. Belt guard
12. On / off switch
13. Drum guard plate
14. Drum guard fasteners
15. 200 mm wide drum
16. Drain extension
17. Dust extractor hose

18. Type plate

Symbols on the product

WARNING! The product can be a
dangerous tool if used incorrectly or
carelessly, which can cause serious or
fatal injury to the operator or others.
Please read the instructions for use prior
to operating the product for the first time.
This symbol indicates that the product
is in conformance with the applicable
European directive.
Wear personal protective equipment. See
Personal protective equipment on page
6 for instructions.
Noise emission to the environment
according to the European Community's
Directive. The product's emission is
specified in the Technical data chapter
and on the label.
Hot surface.
WARNING! Dust forms when cutting, this
can cause injuries if inhaled. Use an
approved breathing mask. Avoid inhaling
exhaust fumes. Always provide for good
ventilation.
4
Caution, risk of cutting.
Low speed.
High speed.
Choke control.
Environmental marking. Symbols on the
product or its packaging indicate that this
product cannot be handled as domestic
waste. It must instead be submitted
to an appropriate recycling station for
the recovery of electrical and electronic
equipment. By ensuring that this product
is taken care of correctly, you can help
to counteract the potential negative impact
on the environment and people that can
otherwise result through the incorrect
waste management of this product. For
more detailed information about recycling
this product, contact your municipality,
your domestic waste service or the shop
from where you purchased the product.
Other symbols/decals on the product refer to special
certification requirements for certain markets.
Type plate
220-240V~ IPX3
XXX XXX XXXrpm
S/N: YYY WWWXXXXX
XXXkW XXXHz
XXXkg
P/N: XXX XXX XXX
130 - 004 - 19.01.2023