Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident does
occur. Let your dealer help you select the correct
personal protective equipment.
•
Regularly do a check of the condition of the personal
protective equipment.
•
Use an approved protective helmet.
•
Use approved hearing protection.
•
Use approved respiratory protection.
•
Use approved eye protection with side protection.
•
Use protective gloves.
•
Use boots with steel toe-cap and non-slip sole.
•
Use approved work clothing or equivalent close-
fitting clothing that has long sleeves and long legs.
Fire extinguisher
•
Keep a fire extinguisher near during operation.
•
Use a powder fire extinguisher or a carbon dioxide
fire extinguisher.
Work area safety
WARNING:
instructions that follow before you use the
product.
•
Do not use the product in fog, rain, strong winds,
cold weather, risk of lightning or other bad weather
conditions.
•
Do not use the product in areas where fire or
explosions can occur.
•
Keep children, bystanders and animals away from
the work area and at a safe distance from the
product.
•
Make sure that only approved persons are in the
work area.
•
Keep the work area clean and sufficiently
illuminated.
•
Remove objects such as screws, bolts, wires and
stones from the work area before you use the
product.
•
Make sure that there are no cables or hoses in the
operation direction of the product.
•
Make sure that there is sufficient airflow in the work
area.
Electrical safety
WARNING:
shocks from electrical products. Do not use
the product in bad weather conditions. Do
not touch lightning conductors and metal
objects. Always use the product as given in
this operator's manual to prevent injury.
28
Read the warning
There is always a risk of
WARNING:
with RCD (residual-current device). An RCD
decreases the risk of electrical shock.
WARNING:
unprotected parts in the power unit. Always
disconnect the power plug before you open
the door to the electrical box.
CAUTION:
the product or generator must be sufficient
and constant to make sure that the motor
operates without problems. Incorrect voltage
causes the power consumption and the
temperature of the motor to increase until
the safety circuit releases. The dimension
of the power cord must agree with national
and local regulations. The dimension of the
mains socket must agree with the amperage
for the electrical socket and extension cable
of the product.
If the power mains has higher system
resistance, short voltage drop can occur
when the product is started. This can
influence the operation of other products, for
example flicker on the lights.
•
Make sure that the power, fuse and mains voltage
are the same as the voltage shown on the rating
plate of the product.
•
Always stop the product before you disconnect the
power plug.
•
Do not use the product if the power cord or power
plug is damaged. Hand it in to an approved service
center for repair. A damaged power cord can cause
serious injury and death.
•
Use the power cord correctly. Do not use the power
cord to move, pull or disconnect the product. Pull the
power plug to disconnect the power cord. Do not pull
the power cord.
•
Do not operate the product in water depths where
the equipment of the product gets wet. The
equipment can become damaged and the product
can become live and cause injury.
•
Do not get more moisture into the product than
the water supplied by the water system. Keep the
product away from rain. Water that goes into the
product increases the risk of electrical shock.
•
Always disconnect the power cord before you
connect or disconnect the connection for the motor
cable and the electrical enclosure.
Grounded product instructions
WARNING:
result in electrical shock. Speak to an
Always use a power supply
High voltage. There are
The power supply from
Incorrect connection can
1819 - 002 - 07.04.2022
Werbung
Inhaltsverzeichnis
Fehlerbehebung
