DRESSER RB 4700 Inbetriebnahmeanleitung Seite 5

Gas pressure regulators for natural gas and all non-corrosive gases
with or without safety shut-off valves for OPSO or OPSO and UPSO
Manufacturer:
Applied conformity assessment
procedures PED:
Applied standards and technical
specification:
Other applied EC-Directives:
Engaged notified body:
Module D, Surveillance of the QS-System: TÜV SÜD Industrie Service GmbH, Westendstraße 199, D-80686 München
Examination/inspections/tests
during manufacturing:
Surveillance of the QS-System:
Regulators and safety devices according to EN 334 and EN 14382 - if not equipped, with any electronic device – do not have a
potential ignition source and therefore are not in the scope of European directive 2014/34/EU.
D2036209_AB_EU_Declaration_RB4700_4600.docx
EU Declaration of Conformity
Itron GmbH, Hardeckstraße 2, D-75185 Karlsruhe
declares under his sole responsibility, that the regulator
RB4710 / 4720 / 4730 without SSV
RB4711/4712/4721/4722/4731/4732 with SSV8500 or SSV8600
RXI4710 / 4720 / 4730 without SSV
RXI4711/4712/4721/4722/4731/4732 with SSV8500 or SSV8600
RB4610 / 4620 / 4630 without SSV
RB4611/4612/4621/4622/4631/4632 with SSV8500 or SSV8600is in conformity
with the Pressure Equipment Directive 2014/68/EU
The regulator has been classified as pressure accessory in category II, by the
manufacturer. The used fluids are classified in group 1 according article 13.
Module D1
DIN EN 334:2005+A1:2009 and DIN EN 14382:2005+A1:2009+AC:2009
2014/30/EU, electromagnetic tolerance
only for optional electronic device
TÜV SÜD Industrie Service GmbH, Westendstraße 199, D-80686 München
DGR-0036-QS-955-17
Karlsruhe, April 21
K. Zinnitsch
Managing director
th , 2018
5