Sequence Cooking; Programming Favourite Settings - Sharp R-956INW Bedienungsanleitung

SEQUENCE COOKING

This function allows you to cook using up to 2 different stages which can include cooking or defrost-
ing. Once programmed there is no need to interfere with the cooking operation as the oven will
automatically move onto the next stage. An audible signal will sound once after the first stage. If one
stage is defrosting, it should be in the first stage of sequence cooking.
1. Press MICROWAVE button once. The display will show P100. (The power level can be
changed by pressing the MICROWAVE button in the following sequence: P100->P80-
>P50->P30->P10->P100.)
2. Use the numeric buttons to input the cooking time. (stage 1 setting)
3. Press GRILL button once. The display will show G-1.
4. Use the numeric buttons to input the cooking time. (stage 2 setting)
5. Press START/+30SEC button to start cooking.
6. When the process is over, the oven will emit a sound and return to standby status. If the
clock has not been set, the display will show 0:00. Otherwise the current time will be
displayed.
Notes:
• If you open the oven door or press the STOP/CLEAR button, the oven will enter the pause
mode.
• Preheat function and auto-menus are not available in sequence cooking mode.
• If one stage is defrosting, it should be in the first stage of sequence cooking.

PROGRAMMING FAVOURITE SETTINGS

This function allows you to program a frequently used cooking sequence to recall it easily for mul-
tiple use. Up to 3 favourite sequences can be programmed.
1. Press MEMORY button once, twice or three times to select the desired memory position.
The display will show 1, 2 or 3 respectively.
2. Press MICROWAVE button once. (The power level can be changed by pressing the MI-
CROWAVE button in the following sequence: P100->P80->P50->P30->P10->P100.)
2. Use the numeric buttons to input the cooking time. (stage 1 setting)
3. Press GRILL button once. The display will show G-1.
4. Use the numeric buttons to input the cooking time. (stage 2 setting)
5. Press START/+30SEC button to memorise the current settings and start the sequence
immediately. Alternatively, you can press MEMORY button to memorise the current set-
tings and return to standby mode. You can also press CLOCK/PRESET button to memo-
rise the current settings and return to programming procedure.
Notes:
• Defrost, preheat and automatic menus settings cannot be memorised.
• Memory content is cleared after a power failure.
GB-19