Switching On Recirculation Mode; Switching Off Recirculation Mode; Clean Air Function - Atag WU70211RM Gebrauchsanweisung

Operation
TIP!
On delivery, this cooker hood is set for exhaust air to the outside. The hood can also be set to
recirculation use (the air is blown back into the room after filtration through grease filters and a
combi-filter).
With an RMS kit (recirculation modification set), the air will first be cleaned by the grease filters,
and then odours will be filtered by the combi-filter. The cleaned air is recirculated back into the
kitchen.

Switching on recirculation mode

Simultaneously press and hold the timer button and the light button until the filter indicator flashes
3 times.
The carbon filter indicator is activated.

Switching off recirculation mode

Simultaneously press and hold the timer button and the light button until the filter indicator lights up
for 3 seconds and then turns off.

Clean Air function

The Clean Air function allows you to freshen the air in your kitchen for a maximum of 24 hours at
level 1.
1. Switch off the cooker hood.
2. Press and hold the timer button for approximately 3 seconds.
The cooker hood will switch on automatically for 10 minutes every hour at the lowest speed
setting. During extraction, the indicator lights show a fast-running light. When the hood switches
off after 10 minutes, the indicator lights show a slow running light until the hood switches on
again after 50 minutes.
3. Switch off the Clean Air function in the meantime by pressing a random button (any button other
than the light button).
10