Making Cappuccino - Ascaso Steel Benutzerhandbuch

PID models - Programming
the coffee dose
PID models have a coffee dose
control function, so that the amount
of coffee required can be adjusted
for both the available options (small
coffee, large coffee).
There is a 3-position
for this process. The two available
coffee selections are obtained by
turning the switch to the top or bottom
positions, while the midpoint turns off
the coffee function.
NB!
The coffee switch
two PID models is not a permanent
setting. Once the function has been
activated, it returns to its original
position. The switch does not have to
stay in the working position; once the
programmed amount of coffee has
been obtained, the function will stop
automatically.
To programme the dose at either
of the two selections, just turn the
switch to the desired position until
the required dose is obtained. On
releasing it, the dose will have been
programmed.
WARNING: To avoid the risk of injury,
do not open the brew chamber during
the brew process.
4.

Making cappuccino

True 'cappuccino' contains 25
millilitres of espresso coffee and
125 millilitres of cold steam-
whipped milk, which goes from 3
or 4 degrees centigrade to nearly
55 degrees centigrade. .Use fresh
cow's milk with a protein content of
over 3.2 percent and a fat content
of 3.5 percent. Whip only the amount
required for one cup in a steel jug
to prevent it from mixing with other
odours or tastes.
MAN.38 V7 - MANUAL STEEL-STEEL PID 2022.indd 35 MAN.38 V7 - MANUAL STEEL-STEEL PID 2022.indd 35
The density of the cream must
be uniform and there must be no
separation from the liquid, or holes
or bubbles.
UNO model
1. Turn on the general switch
coffee switch
2
2. When the pilot light
3. Turn on the hot water/steam knob
on the
2
4. Wait for the pilot light to
faster for about 10 seconds before
steam is generated. Use this signal to
turn the knob on
5. Immerse about half of the steam
6. When finished, turn both the water/
7. If you want to obtain more than
finished, the machine temperature will
be too high to make coffee. The pilot
light
returns to the correct temperature.
Follow point 2.B to force cooling.
system includes a safety limit that
cuts off the service after 3 minutes of
continual operation.
The pilot lights come on
6 flash.
6
flashing, turn on the steam switch
. The pilot light comes on
3
and flashes.
6
and let water flow until it runs
4
discontinuously. Turn it off.
on without flashing This shows
that the water has reached the
right temperature. The pump will
start to work in bursts. When this
happens, turn on the knob again
to obtain steam 4 .
NB!
The pilot light
6
.
4
wand in the milk to heat it.
5
steam knob 4 and the steam
switch off.
3
three consecutive cappuccino
services, or make more coffee
afterwards, see sections 2B and
2C.
NB!
When the steam service is
6 will flash until the machine
NB!
The steam generation
ascaso
1
, and
13
stops
15
6 come
will flash
35
01/06/2022 9:30:22 01/06/2022 9:30:22