OP Link TripleShield Benutzerhandbuch Seite 15

V 2.2.0t1b
Set up and wall-mount the motion sensor
Step 1: Insert Battery
a. Lift top tab on cover to release and remove cover.
b. Insert the battery noting the polarity (CR123A), and replace the cover onto the sensor.
Step 2: Install Motion Sensor
a. Place the motion sensor appropriately to ensure maximum coverage of a monitored
area. The motion sensor monitors any movement up to 35 feet away and should not
be placed higher than 7 feet from the floor.
b. For maximum coverage, it is recommended that the sensor be placed in the corner
of the room to be monitored.
c. Use the larger piece or the two thin pieces of double-sided tape to mount the
motion sensor at the desired location on the wall or corner of the room.
d. Make sure the motion sensor is placed at an angle with the least amount of
obstruction for best coverage.
e. The sensor is most effective in areas such as hallways and entry points where
intruders will have to pass through.
3-Minute Cool Down Period
A 3-minute cool down period is programmed into the Motion Sensor. This helps reduce false alarms and
prolongs battery life. After the most recent event has been triggered, the next motion detected by the sensor
can happen only after the 3-minute countdown has elapsed. When/If motion is detected within the cool
down period, the 3-minute countdown will restart.
Initial Test Mode and Power-Save Mode
The Motion Sensor has 2 modes: Initial Test Mode and a Power-Save Mode.
•
The Initial Test Mode occurs during the first hour after a battery is put into the device, as is the
case during the initial installation of the system. Within this hour, whenever the Motion Sensor
Oplink Communications, Inc.
14