OP Link TripleShield Benutzerhandbuch Seite 12

V 2.2.0t1b
Battery Installation
To install the sensors:
1. Each Door/Window Sensor set consists of two pieces. Take the larger piece and with
slight force, push the small tab on the back plate outward and slide the back plate
upward. Remove the back plate and insert a battery into each Door/Window Sensor set.
2. Apply the double-sided tape to the backs of each piece.
3. Door/Window (It is recommended that the Door/Window Sensor be mounted in a
vertical/upright position.)
a. On your door:
i. After selecting a location on the door, preferably on the edge of the door
Apply Double-Sided Tape
Sensor DWM1301 Installation
away from the hinges, the large unit of the sensor should be placed on
the immovable frame of the door.
Oplink Communications, Inc.
Magnet/Sensor Positioning
11