Rommelsbacher CT 3408/IN Bedienungsanleitung Seite 10

• Induction cooking provides for extra safety: Even when the cooking utensils are removed
from the cooktop without having turned it off, the heating process is interrupted automatically.
In case a cloth or another combustible material should be placed on the cooktop by accident,
it cannot burn even if the cooktop has been activated. After the cooking process, nothing but
the residual heat emitted by the pot is noticeable on the glass ceramic plate.
• The cooking surface is very easy to clean. As it is not heated directly, leftovers cannot scorch.
Neither do you have to wait for it to cool before cleaning.
Selecting pots and pans
• Suitable: any fl at-bottomed (8 - 24 cm in diameter) cooking utensils made of iron,
such as enamelled pots, pots made of cast iron or of magnetic stainless steel.
• Unsuitable: any cooking utensils consisting of aluminium, copper, glass or ceramic, pots
made of unmagnetic stainless steel, as well as any pots having a pot diameter of less than 8 cm.
• Tip: Check by means of a magnet whether the pot bottom is suitable. If the magnet clings to
the outside of the pot bottom, the vessel is qualifi ed for induction cooking.
Your new appliance at a glance
a) The control panel
display
LED displays for
operating mode indication
Every actuation of a button is verifi ed by an audible acknowledgement signal. Please activate
the buttons with your fi ngertips only for damages to be avoided.
b) Initial use
Place the appliance on a heat-resistant, stable and fl at working surface (non-metallic!) and do
not operate it in the proximity of other appliances (electric stove, gas fl ame etc.). The space
above the appliance must be free. The distance to any wall must be at least 10 cm. Unhindered
air circulation has to be ensured.
Connect the appliance to the power supply. There will be a short audible signal and the red LED
displays above the main switch sensors of the two cooktops will glow. The fan initiates a short
function test and then the appliance is in the stand-by mode.
10
„POWER" sensor
(power levels)
„-" and „+" sensors
(to change parameters)
„TEMP" sensor
(temperature levels)
„TIMER" sensor
(operating time)
LED display for
operating mode
ON/STANDBY
main switch sensor
ON / STANDBY