Dell XPS 8950 Servicehandbuch Seite 71

Table 4. System setup options—System Configuration menu (continued)
System Configuration
SATA Operation
Drives
SATA-0
SATA-1
SATA-2
SATA-3
M.2 PCIe SSD-2
SMART Reporting
USB Configuration
Enable Boot Support
Enable Front USB Ports
Enable Rear USB Ports
Front USB Configuration
Rear USB Configuration
Audio
Table 5. System setup options—Video menu
Video
Multi-Display
Primary Display
Table 6. System setup options—Security menu
Security
Internal HDD-2 Password
Internal HDD-3 Password
M.2 SATA SSD Password
Strong Password
Password Configuration
Password Change
UEFI Capsule Firmware Updates
PTT Security
PTT On
Clear
PPI ByPass for Clear Command
Absolute(R)
Configure operating mode of the integrated SATA hard drive controller.
Enable or disable various drives on board.
Displays the SATA device information of the computer.
Displays the SATA device information of the computer.
Displays the SATA device information of the computer.
Displays the SATA device information of the computer.
Displays the M.2 PCIe SSD information of the computer.
Enable or disable SMART Reporting during system startup.
Enable or disable booting from USB mass storage devices such as external
hard drive, optical drive, and USB drive.
Enable or disable the front USB ports.
Enable or disable the rear USB ports.
Enable or disable the front USB ports.
Enable or disable the rear USB ports.
Enable or disable the integrated audio controller.
Enable or disable multiple displays.
Set or change the primary display.
Set, change, or delete the internal hard-disk drive password.
Set, change, or delete the internal hard-disk drive password.
Set, change, or delete the M.2 solid-state drive password.
Enable or disable strong passwords.
Control the minimum and maximum number of characters allowed for Admin
and System passwords.
Enable or disable changes to the System and Hard Disk passwords when an
administrator password is set.
Enable or disable BIOS updates through UEFI capsule update packages.
Enable or disable Platform Trust Technology (PTT) visibility to the operating
system.
Default: Disabled
Enable or disable the TPM Physical Presence Interface (PPI). When enabled,
this setting will allow the OS to skip BIOS PPI user prompts when issuing
the Clear command. Changes to this setting take effect immediately.Default:
Disabled
Enable or disable the BIOS module interface of the optional Computrace(R)
Service from Absolute Software.
System-Setup 71