Signals Displayed - Endress+Hauser Commubox FXA291 Bedienungsanleitung

Commubox FXA291
12.1.2 Connecting the computer and the measuring device
NOTICE
Incorrect adapter cable
Can render the approved explosion protection properties invalid
‣
Only use the TOF adapter FXA291 - which is available as a accessory - to connect the
Commubox to the CDI interface of the following devices: FMR2xx, FMR53x, FMR540,
FMP4x, FMU4x, PMC71, PMP7x, PMD7x, FMD7x, FMB70, FMG60.
1. Connect the CDI connector of the adapter cable to the CDI interface of your measuring
device.
2. Switch on the computer.
 Wait until your operating system is completely ready.
3. Connect the USB cable of the Commubox to a USB port of your computer.
 Wait until the connection is detected automatically. Where applicable, confirm the
installation of necessary, automatically detected drivers.
4. Start communication with the measuring device, e.g. via FieldCare for example.
12.2

Signals displayed

 7 Indicator lights (USB connection/PC side)
Signal Light
READY Green
Tx / Rx Red
Tx / Rx Yellow
Tx / Rx Orange
Endress+Hauser
Meaning
Commubox FXA291 is operational
Communication from computer to field device
Communication from field device to computer
Duplex communication
Commissioning
A0005933
21