Dust/Chip Extraction; Starting Operation - Bosch GBH 7-46 DE Professional Originalbetriebsanleitung

All manuals and user guides at all-guides.com
OBJ_BUCH-414-002.book Page 18 Tuesday, July 6, 2010 10:37 AM
18 | English
Inserting (see figure A)
– Clean and lightly grease the shank end of the
tool.
– Insert the tool in a twisting manner into the
tool holder until it latches itself.
– Check the latching by pulling the tool.
Removing (see figure B)
– Push back the locking sleeve 2 and remove
the tool.

Dust/Chip Extraction

Dusts from materials such as lead-containing
coatings, some wood types, minerals and metal
can be harmful to one's health. Touching or
breathing-in the dusts can cause allergic reac-
tions and/or lead to respiratory infections of the
user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in con-
nection with wood-treatment additives (chro-
mate, wood preservative). Materials containing
asbestos may only be worked by specialists.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your country
for the materials to be worked.
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Setting the Operating Mode
The operating mode of the power tool is select-
ed with the mode selector switch 3.
1 609 929 V45 | (6.7.10)
Note: Change the operating mode only when the
machine is switched off! Otherwise, the ma-
chine can be damaged.
– Turn the mode selector switch 3 to the re-
quested position.
Position for hammer drilling
When the drilling tool does not
immediately rotate upon switching
on, allow the machine to run slowly
until the drilling tool rotates.
Vario-Lock position for adjustment
of the chiselling position
Position for chiselling
In the "chiselling" position, the impact rate
preselected with the thumbwheel 5 is automat-
ically increased when switching on; this causes
the power tool to operate with increased capac-
ity when chiselling.
Switching On/Off in Drilling Mode
– To start the machine, press the On/Off
switch 4 and keep it pressed.
– To switch off the machine, release the
On/Off switch 4.
Switching On/Off in Chiselling Mode
– To start the machine, press the On/Off
switch 4 at the top (I) until it locks.
– To switch off the machine, press the On/Off
switch 4 at the bottom (0) and release it.
For low temperatures, the power tool reaches
the full hammer/impact capacity only after a cer-
tain time.
Bosch Power Tools