Maintenance and Cleaning
Automatic Defrosting of the
Refrigerator
There is no need to defrost the refrigerator,
because ice depositing on the inner back wall
is defrosted automatically. Ice is depositing on
the inner back wall during the compressor
operation; later on, when the compressor is not
operating ice is defrosting and water drops
collect and drain through the outlet in the inner
back wall into the drain pan situated above the
compressor, from where it evaporates.
Use the rod provided to clear any
blockages.
Cleaning
rod
Manual Defrosting of the Frezing
Compartment
When the frost and ice layer in the frezing
compartment is 3-5 mm thick, you should clean
the freezer.
• Turn the thermostat knob to STOP (0)
position, and disconnect the power supply.
Empty the compartment and take care that
the packages remain frozen.
• Put a suitable vessel under the frezing
compartment to collect the defrost water.
Leave the door of the compartment open to
accelerate defrosting.
• Avoid using defrosting sprays, as they may
cause damage to the plastic parts and may
be hazardous to health.
Cleaning the Appliance
Disconnect the power supply before cleaning
the appliance.
Do not use coarse or aggressive cleaning
agents as you can damage the surface. Be
careful to remove any cleanser agent
remaining after cleaning.
• Clean the exterior with water and detergent.
• Varnished surfaces are cleaned with soft
cloth and an alcohol based cleaning agent
(for example glass cleaners). You may also
use alcohol (ethanol or isoprophylic alcohol).
• The application of abrasive and specially
aggressive cleaners, such as the stainless
steel cleaners, is not appropriate for the
cleaning of plastic and coated parts.
• Remove the detachable accessories in the
interior of the appliance and clean it with
water and liquid detergent. Plastic parts
cannot be washed in washing machine.
• Wash the interior of the appliance with
lukewarm water, in which you added one or
two spoonfuls of vinegar.
• Every now and then wipe the condenser on
the rear wall. Use soft non-metal brush or
vacuum cleaner.
• Do not forget to clean also the defrost water
receptacle above the refrigerator
compressor (do not remove the receptacle).
After cleaning, connect the appliance to power
supply and reload it.
Switch Off the Appliance When Not In
Use
If you do not intend to use the appliance for a
longer period, set the thermostat knob to the
STOP (0) position, disconnect the power
Instructions for Use
13