Placing And Installation - Gorenje RU5004A++ Bedienungsanleitung

household waste disposal service or the
shop where you purchased the product.
Disposing of the Worn Out Appliance
• When your appliance finally wears out,
dispose it of. If the appliance has a lock,
break it, in order to prevent eventual

Placing and Installation

Choosing the Right Place
Place the appliance in a dry and regularly
ventilated room. Allowed ambient temperature
depends on the model (class) of the appliance
and is stated on the rating plate of the
appliance. Never place the appliance near heat
emitting devices (e.g. cooker, radiator, water
heater or similar devices) and do not expose it
to direct sunlight. The appliance should be
positioned at least 3 cm away from the electric
or gas cooker and at least 30 cm away from the
oil or coal stove. If this is not possible, use an
appropriate insulation. Behind the appliance
there should be free space at least 200 cm
wide and above the appliance the high kitchen
units should be at least 5 cm away from the
appliance in order to assure adequate
ventilation of the condenser unit.
Class Ambient temparature
SN (subnormal) from + 10°C to + 32°C
N (normal) from + 16°C to + 32°C
ST (sub-tropical) from + 16°C to + 38°C
T (tropical) from + 16°C to + 43°C
Location
• Place the appliance horizontally and firmly
on a solid base. Level the appliance with four
adjustable feet.
4
accidents (danger of children get locked
inside the appliance).
• The refrigerating system of the appliance is
filled with refrigerant and insulating
substances which should be separately
treated and processed. Call your nearest
authorised service agent or specialised
servicing centre. If you don't find one, contact
your local authorities or your distributor. Be
careful not to damage the tubes on the rear
wall of the appliance (danger of pollution).
Connection to Power Supply
Connect the appliance with the cable and plug
to the power supply socket outlet with a ground
terminal (safety socket). Required nominal
voltage and frequency are indicated on the
rating plate. The connection to the mains
supply and earthing have to be made according
to current standards and regulations.
2
Instructions for Use