Axminster AW305WL Originalanleitung Seite 6

ASSEMBLY
Fig 01-02
Tool Holder
Locate the tool holder (I) the two Phillips screws and
washers, see fig 3. Place a washer over the screws
and screw them into the two pre-drilled holes below
the headstock, see fig 4.
NOTE: There are also two pre-drilled holes under
the tailstock if you wish to mount the tool holder
there.
NOTE GIVE ADEQUATE GAP
BETWEEN THE SCREW HEAD
AND LATHE CASTING!
Fig 03-04
I
Line up the machined slots in the tool holder (I)
and slide the holder down over Phillips screws then
lightly tighten the screws to clamp the holder in
place, see figs 5-6.
DON'T OVERTIGHTEN THE
PHILLIPS SCREWS AS THE
HOLDER IS ONLY PLASTIC!
F G
Tailstock Handle
Locate the tailstock handle and screw it into the
threaded hole in the tailstock wheel, see fig A.
J J
6
Fig 05
Fig 06
Fig A