Werbung
Regulatory Model Identification Number
For regulatory identification purposes, this product has been assigned a Regulatory Model Number (RMN).
The RMN for your product is SHNGD-1605. The RMN should not be confused with the marketing name
(HP ScanJet Wireless Adapter 100) or the HP Product Number (L2761A).
Notice for the U.S.A.
This device complies with Part 15 of the Federal Communication Commission rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful interference, and 2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at this own expense. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
•
FCC Caution: The FCC requires the user to be notified that any changes or modifications made to this device
that are not expressly approved by
HP Inc. may void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received,including interference that may cause undesired operation.
Warning – Exposure to Radio Frequency Radiation Although the radiated output power of this device
isbelow the FCC radio exposure limits, the device should be used in such a manner that the potential for
humancontact with the antennas during normal operation is minimized. To avoid the possibility of exceed-
ing theFCC radio frequency exposure limits, human proximity to the antenna should not be less than
20 cm (8 inches) during normal operation.
78
Werbung
