Maintenance - Lavor GV EGON VAC Bedienungsanleitung

CAUTION! Before any maintenance or cleaning operation,
remove the plug from the socket.
Clean the outside of the appliance with a damp cloth.
Do not use solvents or detergents.
Don not use solvents, which could damage the plastic parts of
the appliance.
Do not steam-clean the appliance.
Empty the tank (M) every time you finish using it (see section
"Emptying the tank")
Periodically, for easier internal cleaning, it is possible to release
the baffle (Z) inside the tank (M) (Fig. 57): lever out and
carefully release both ends of the inner baffle (Z). For
reassembly, fit the baffle on the tank edge and hook the ends.
Clean the soleplate of the iron while it is warm (use special
products available on the market).
Only use water to clean the attachments.
To eliminate dirty residues from the inside of the attachments
(tubes, extension or brushes), wash the internal vacuuming
ducts with running water.
CAUTION! Do not wash or immerse the flex (1) in water or
any other liquid.
To prevent the brushes from becoming misshapen, leave the
clean brushes to dry with the bristles facing upwards.
The appliance is supplied with a kit of spare seals. Periodically,
check if the seals are worn out and, if necessary, replace them.
• Solids filter (R): (Fig. 58) Inspect and wash with running
water.
Best to replace every 6 months.
• Microfibre filter (P): (Fig. 59) wash inside with running
water, let dry before reassembling the filter assembly.
EN

14 MAINTENANCE

Fig. 57
M
Fig. 58
Fig. 59
P
Fig. 60
Q
Z
51