ULTIMATE SPEED UPK 10 E2 Originalbetriebsanleitung Seite 19

Step
1. Connect the
jump lead
18
of the power
bank with
compressor
1
to the car-
jumpstart-outlet
of the
8
power bank
with
compressor
1
2. First connect
the red clamp
(A) to the
positive pole
of the vehicle
battery and
then connect
the black bat-
tery clamp (B)
to the negative
pole (see
Fig. 1).
3. Starting up the
vehicle.
LEDs
Red Error LED
continuously lit on
the jump lead
Green Start LED
and the red
19
.
flash
Error LED
20
alternately.
The red Error
LED flashes,
20
a short alarm
signal sounds.
The red Error
LED flashes, a
20
continuous alarm
signal sounds.
The red Error LED
flashes once,
20
a continuous alarm
is sounded and
then followed by
two short alarm
sounds.
Green Start LED
and the red
19
Error LED flash
20
alternately. After
1–2 seconds only
the green LED
glows.
Meaning /
Error
The voltage
is
20
determined in
the power bank
.
18
with compressor
is not enough
1
to start the car.
Power bank with
compressor
ready.
The tempera-
ture is too high,
possibly due to
several jump
start attempts.
Battery clamps
(A) and (B) are
the wrong way
round.
It is caused by
a short circuit
or the battery is
leaking.
The connection
is correct.
19
Solution
Charge
the power
bank with
compressor
Carry on to
step 2
1
Disconnect
the black (B)
battery clamp
first and then
the red clamp
(A) from the
battery poles.
Start again
from step 1.
Carry on to
step 3
GB/IE/NI/CY/MT
.
1
19