Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Strobe effect
In FLASH mode the speed for strobe effect can be set.
1
Press the MENU button so many times until FLASH is indicated in the display Confirm with the ENTER
2
Use the buttons UP and DOWN to adjust the desired speed (0-9). Confirm with the ENTER button.
Behavior at missing DMX-signal
In DMX LOST mode the program offers different options when no DMX signal is received.
1
Press the MENU button repeatedly until the display shows the DMX LOST menu. Confirm with the
ENTER button.
2
Select the desired program with the UP and DOWN buttons (see menu structure). Confirm with the
ENTER button.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1
Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAVE is indicated in the display. Confirm with the ENTER button.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3
Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.
Potentiometer
If you select "on" in the POTENTIO menu item, the brightness and color temperature rotary controls are
activated. When set to "oFF", they are disabled.
Quick access via rotary knob:
The brightness and color temperature can be controlled via the rotary controls on the back of the device (see
device overview), thus providing quick access to the static settings.
PWM (Pulse-width modulation)
In the menu PWM freq the PWM frequency off the LEDs can be set.
1
Press the MENU button repeatedly until the display shows the PWM freq menu. Confirm with the
ENTER button.
2
Select the desired PWM frequenzy (900-25kHz) with the UP and DOWN buttons. Confirm with the
ENTER button.
30/36
00138004, Version 1.0
Werbung
Inhaltsverzeichnis
