Storch Airless ST 1700 Betriebsanleitung Seite 193

Cleaning without the cleaning adapter
1. Perform steps 1 - 4 of the pressure relief action. Remo-
ve the tip guard from the spray gun.
NOTE: Use water for water-base material, mineral spirits
for oil-base material, or other solvents recommended by
manufacturer.
2. Turn power on. Turn the circulation valve forward to
6. Open the pressure
relief valve and check
on the pressure gau-
ge that the system is
depressurised and the
display shows "0 bar".
Note: read Section
"Designation of compo-
nents D"
7. Place the circulati-
on hose in an empty
bucket and open the
water valve.
8. Switch on the Air-
less device at the On/
Off switch, slowly turn
the pressure regulator
to the "9 o'clock posi-
tion" (the motor slowly
starts) and rinse until
clear water escapes
from the circulation
hose.
9. Hold the Airless gun
into and at the inner
edge of the bucket
with the collected
waste water, unlock
the trigger lock on the
Airless gun and pull
and hold the trigger on
the gun.
193
SPRAY position.
3. Increase the pressure by half. Hold gun against pail.
10. Now close the
pressure relief valve
and water now flows
through the Airless
hose and the gun. Now
rinse until clear water
escapes. Change bet-
ween the two circuits
by opening and closing
the pressure relief val-
ve.
Note: Read in Section
"Designation of compo-
nents D+E"
11. Switch off the
device, open the pres-
sure relief valve and
the housing of the
device filter and clean
it.
CAUTION:
Clean the device as
follows if a water
connection is not avai-
lable.
Original instruction