Storch Airless ST 1700 Betriebsanleitung Seite 189

1. Apply a spray test pattern. Increase pressure to elimi-
nate heavy edges. Use smaller tip size if pressure adjust-
ment can not eliminate heavy edges.
If this still does not work, reduce the material viscosity
(note material manufacturer's specifications).
2. Hold gun perpendicular, 25 - 30 cm from surface.
Spray back and forth. Overlap by 50 %. Trigger gun after
moving and release before stopping.
Clearing Tip Clogs
Nozzle table/nozzle selection guide
Glazes
Processable ma-
Alkyd resin lacquer
terials
Acrylic lacquer
Spray width 7 9 10
10 cm 207 209 210
15cm 307 309 310
20cm 409 410
25cm
30cm
35cm
Interior emulsions
Primers
Exterior emulsions
Pre-coats
Adhesive for fibreglass wallpaper
Nozzle drilling in 1/1000" (example: 8 = 0.008") and nozzle marking
11 12 13 15 17 19
211 212 213 217 219
311 313 315 317 319
411 413 415 417 419
511 513 515 517 519
619
To avoid serious injury, never point gun at your hand or
into a rag.
1. Release trigger, engage trigger lock. Rotate Switch Tip.
Disengage trigger lock. Trigger gun to clear clog.
2. Engage the trigger lock. Return Switch Tip to original
position. Disengage trigger lock and continue spraying.
Flame protection
Bitumen material
Light filler
21 23 25 27 29
321
421 423 425
521 523 525 527 529
621 623 625 627
721
189
Other spray fillers
31 33 35 37 39 41
235
431
531 535
631 633 635 637 639 641
735
Original instruction
43
543
643