Environmental Protection / Disposal; Warranty; Declaration Of Conformity - Protool RGP 80-11 E Originalbetriebsanleitung

- If the suction fl ange height adjustment
system does not operate smoothly, the
fl ange must be removed and cleaned.
WARNING
Authorised PROTOOL service shops
carry out entire maintenance work
and repairs that require opening of
motor's cover are allowed only.
- Service – see enclosed sheet.
10 Environmental
Protection / Disposal
Power tools, accessories and packaging
should be sorted for environmental-friendly
recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical and elec-
tronic equipment and its incorporation into
national law, power tools that are no longer
suitable for use must be separately collect-
ed and sent for recovery in an environmen-
tal-friendly manner.
REACh
REACh is a European Chemical Directive
that came into effect in 2007. As "down-
stream users" and product manufacturers,
we are aware of our duty to provide our
customers with information. We have set up
the following website to keep you updated
with all the latest news and provide you
with information on all the materials used
in our existing products:
http://www.tts-protool.com/reach

11 Warranty

For our tools, we give warranty for material
and production defects in accordance with
the locally applicable legal provisions, but
in any case for at least 12 months. Within
the EU member states, the warranty period
is 24 months (verifi cation through invoice
or delivery note).
20
Damage caused by, in particular, natural
wear, overloading, incorrect handling, or
damage caused by the operator, or dam-
age caused through use of the equipment
contrary that specifi ed in the Operating In-
structions, or damage which was known at
the time of purchase, is not covered by the
warranty. Furthermore, damage caused by
the use of non-original PROTOOL accesso-
ries and consumable material (e.g. sanding
pads) is also excluded.
Complaints can only be recognised if the
tool is returned while still assembled to the
supplier or an authorised PROTOOL Cus-
tomer Service workshop. Keep the Operat-
ing Instructions, Safety Instructions, Spare
Parts List and purchase receipt in a safe
place. Otherwise the respective, current
warranty condi tions of the manufacturer
shall apply.
Note
Due to continuous research and develop-
ment work, we reserve the right to make
changes to the technical content of this
documentation.
12 Declaration of
Conformity
We declare under our sole responsibility
that this product is in conformity with the
following standards or standardization doc-
uments:
EN ISO 12 100, EN 55 014-1, EN 55 014-2,
EN 60 745-1, EN 60 745-2-3, EN 61 000-3-2,
EN 61 000-3-3 according to the provision
of the regulations stipulated in Directive
98/37/EC (until 28 Dec. 2009), 2006/42/EC
(from 29 Dec. 2009), 2004/108/EC.
09
Manfred Kirchner
Research and development
Protool GmbH
Wertstr. 20
D-73240 Wendlingen
31. 5. 2009