Control Elements; Notes On Safety Prevention; General Safety Instructions; Safety Instructions For All Work Activities - Protool RGP 80-11 E Originalbetriebsanleitung

4

Control Elements

[1-1] Additional handle
[1-2] Switch lever
[1-3] Adjusting wheel
[1-4] Handle
[1-5] Knob
[1-6] Backstop bar
[1-7] Suction fl ange
[1-8] Scale
[2-1] Bolt
[2-2] Retainer
[2-3] Washer
[2-4] Milling rings
[2-5] Tool carrier
[2-6] Guide surface
[2-7] Bolt
[2-8] Sliding part
[2-9] Slot
[2-10] Suction fl ange
[2-11] Guide surface
Not all of the accessories illustrated or de-
scribed are included as standard delivery.
5 Notes on Safety
Prevention
DANGER

5.1 General Safety Instructions

- Before using the machine, carefully read
all safety instructions and the Operating
Instructions.
- Keep all of the attached documents and
pass on the documentation if the ma-
chine changes ownership.
5.2 Safety instructions for all
work activities
Safety warnings common for the
following works: grinding, surface
grinding, grinding with wire brush or
abrasive cutting:
a) This electromechanical tool is de-
signed to be used as a surface grinder
or a cutter with a cutter head. Read
all safety warnings, instructions, il-
lustrations and specifi cations intend-
ed for this electromechanical tool.
Failing to meet all the below specifi ed
14
instructions may lead to injury by electric
current, fi re and/or serious injury.
b) This tool is not recommended for pol-
ishing or cutting. Execution of works
this tool is not designed for may create
a risk and cause injury of a person.
c) Do not use accessories which is not
explicitly designed and recommended
by the tool manufacturer. The fact that
the accessories an be attached to your tool
does not guarantee its safe operation.
d) Nominal rpm of accessories must be
at least equal to the maximum rpm,
stated on the tool. Accessories that op-
erate at higher rpm than are the nominal
rpm, may break and pull apart.
e) Outer diameter and thickness of your
accessories must be within the limits
of nominal range for your electrome-
chanical tool. Accessories of incorrect
dimensions cannot be either protected
enough or controlled properly.
f) Clamping dimensions of disks, fl anges,
supporting plates or any other acces-
sories must be suitable for fi xing to
the tool spindle. Accessories with clamp-
ing holes which do not correspond with the
mounting dimensions of electromechani-
cal tool will be unbalanced, may vibrate
excessively and cause loss of control.
g) Do not use damaged accessories.
Check the accessories prior to each
use: check the grinding wheels for
chips and cracks, check the sup-
porting plates for cracks, ripping
or excessive wear, check the wire
brushes for loose or cracked wires. If
accessories or tool fell down, check
the damage or mount undamaged
accessories. After the accessories
is checked and mounted, you and
also bystanders stand to be beyond
the level of rotating accessories and
leave the tools run free at highest
rpm for one minute. During this trial
time damaged accessories usually rips
apart or disintegrates.
h) Use personal protective means. De-
pending on use, use facial shield and
safety protective goggles. If appro-
priate, use dust mask, ear protec-
tors, gloves and work apron, capa-