Pre-Operation Check - Honda hsm1336i Bedienungsanleitung

Check the snowblower on level ground with the engine stopped.
To prevent accidental start-up, remove the engine switch key before
performing the pre-operation check.
Fuel
Inspection:
Check whether the fuel gauge needle is in the FULL position.
If the needle is not in the position, fill the fuel tank to the level shown.
Refilling:
Use unleaded gasoline with a Research Octane Number of 91 or
higher (a Pump Octane Number of 86 or higher).
Never use stale or contaminated gasoline or an oil/gasoline mixture.
Avoid getting dirt or water in the fuel tank.
Remove the fuel filler cap and fill the tank with the recommended
gasoline.
Do not fill the fuel tank completely. Fill tank to approximately
35 mm (1.4 in) below the top of the fuel filler neck to allow for fuel
expansion.
After refueling, make sure the fuel filler cap is closed properly and
securely.
FUEL
FILLER
NECK
MAXIMUM
FUEL LEVEL
35 mm
(1.4 in)

PRE-OPERATION CHECK

5.
FULL
FUEL FILLER CAP
FUEL GAUGE
29