Setup And Operation; Placing The Receiver; Connecting The Receiver - Omnitronic E2 Bedienungsanleitung

4 Setup and Operation

4.1 Placing the receiver

1) Place the receiver on an even surface and connect the antennas provided to the antenna jacks. Put the
antennas upright in a V-shaped position. Please note that the antennas provided are suitable for use in
good reception conditions. If more than one receiver is to be used, it may be better to use remote
antennas and, if necessary, an antenna splitter.
2) For 19" rack installation (483 mm) screw on the two mounting brackets provided at the left and right
sides of the housing. For rack mounting, the rod antennas can be attached to the front panel.
Notes
• In order to ensure sufficient cooling of the unit, air must always be able to flow freely through all air vents.
• Place the receiver at least 1 meter above the ground and not too close to lateral walls.
• Avoid sources of interference such as metal surfaces or electronic devices (e.g. computer, CD player).
• Ideally, position the receiving antennas at the height of the transmitter. When using multiple systems, do
not allow antennas to cross or touch each other.
• For optimum reception, keep the transmitter at least 1 meter away from the receiver and avoid obstacles.

4.2 Connecting the receiver

1) Connect the receiver to the subsequent unit:
• The balanced XLR outputs of the individual channel outputs can be connected to a microphone input
each of a mixer.
• Use the unbalanced 6.3 mm jack "MIX OUT" for the master signal of all receiving channels for
connection to a microphone input or a highly sensitive line input via the connection cable provided.
2) Finally, connect the power adapter to the power input of the receiver and the mains plug to a mains
socket. Pass the cable through the cable grip. Use the receiver only with the supplied power adapter.
Always disconnect the mains connector when you wish to change connections, move the unit to a
different place or if it is not used for a longer period.
1 PA system
E4 Receiver
3
19 • EN
Mixing console
2