Special Instructions - clearaudio electronic Master Solution Bedienungsanleitung

5. You can now mount your tonearm on the acrylic board mounted on one
base of the turntable. After that you can mount your cartridge according to
the manufacturer's instructions.
6. After this you can place a record on the turntable platter, and fix it with the
enclosed clever-clamp and finish your cartridge adjustments.
Master Solution
The clearaudio
way you have never heard it before. Enjoy listening !

4. SPECIAL INSTRUCTIONS

Please take the time to fill out the enclosed warranty card and return it to Clearaudio or your local
distributor / dealer. This will guarantee you a fully covered warranty on your product.
During any transportation of the turntable, always remove the platter and inverted bearing and put a
security tape on the. If this is not done, DAMAGE COULD OCCUR!
Please regularly check the mains leads of your motor assembly. If there is any damage to any wires
or the mains plug, have them replaced immediately only by a qualified person (your dealer or
distributor).
To clean the turntable, use only special acrylic cleaner, which is not alcohol based. Otherwise you
could could damage the material (haircracks and spots on the acrylic surface).
Master Solution
Keep your clearaudio
environments
Seite 14
turntable is now ready to play analogue the
turntable out of extreme temperature and extreme moisture
Master Solution
© clearaudio electronic GmbH 2006
Bedienungsanleitung