Operation; Daily Use - REX RDTF24/7C Benutzerinformation

8
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
Levelling
When placing the appliance make sure
that it stands level. This can be achieved
by two adjustable feet at the bottom in
front.
Rear spacers
In the bag with the documentation, there
are two spacers which must be fitted as
shown in the figure.
If you position the appliance against a wall
in a freestanding installation, install the

OPERATION

Switching on and off
To switch on the appliance, insert the plug
into the wall socket.
When the appliance is switched
on for the first time, the interior
light may turn on after a one-
minute delay due to opening
tests.
To disable all the functions,
activate the Standby mode.
Refer to the "Standby mode"
section.
To switch off the appliance, unplug it.
Temperature regulation
The temperature is regulated
automatically. However, you can set a
temperature inside the appliance yourself.
Turn the temperature regulator to a higher

DAILY USE

Removing and installing the
door shelf
To remove the door shelf:
rear spacers in order to guarantee the
maximum possible distance.
Door reversibility
Reversing the door swing is not possible.
position to lower the temperature inside
the appliance.
Thermostat settings:
• 1 - 2: for short-term storage of food in
the freezer compartment.
• 3 - 4: for long-term storage of food in
the freezer compartment.
• 5 - MAX: for freezing fresh food. Once
the food in the freezer compartment is
fully frozen, reset the thermostat to its
original position.
Choose the setting keeping in mind that
the temperature inside the appliance
depends on:
• room temperature,
• frequency of opening the door,
• quantity of food stored,
• appliance location.
A medium setting is generally the most
suitable one.
1. Hold the left side of the shelf.