Hyundai 56255 Bedienungsanleitung Seite 11

DESCRIPTION (FIG. A1 - B4)
Your mitre saw has been designed for
sawing wood and wood products.
1. Laser
2. Laser on/off switch
3. Laser cover
4. Power cord
5. Cutting arm
6. Head lock
7. Control lever
8. Handle
9. Upper fixed guard
10. Work clamp
11. Lock for work clamp
12. Rotating guard
13. Guard retraction arm
14. Protective cap screw
15. Connection for dust extraction
16. Bevel angle lock
17. Bevel scale
18. Guide
19. Mitre table
20. Mitre scale
21. Table inlay
22. On/off switch
23. Table locking lever
24. Mitre lock
25. Axle lock button
26. Slide rod
27. Push rod clamp screw
28. Slot depth adjustment screw
29. Depth stop
30. Lock nut slot depth
31. Slot stop
32. Saw head tilt adjusting screw
33. 0° adjustment screw
34. Switch lock button
35. Table extension (x2)
Packaging contents
• Mitresaw
• Workpiece clamp
• Table extension bracket (2x)
• Allen key
• Dust bag
• Instructions for use
• Safety regulations
• Guarantee and service
ASSEMBLY
Dust bag (fig. A1 + A4)
• Clamp the dust bag to the dust bag connection
(15).
• Empty the dust bag when it is 2/3 full.
Table extension brackets (fig. A2)
• Insert the brackets into the openings on the
sides of the base.
• Lock the brackets with the screws on the front of
the base plate.
Workpiece clamp (fig. A1)
The adjustable workpiece clamp (10) can be placed
on both the left and the right.
Always fix the workpiece in place using
the workpiece clamp.
Placement of the machine (fig. A1)
• The machine must be attached to a solid and
flat surface using nuts and bolts (not supplied).
• First mark out the mounting holes on the
workbench.
• Drill holes on the marked locations.
• Position the machine on the workbench and
insert the bolts through the mounting holes.
• Fit locking rings and tighten the bolts properly.
USE
Always fix the workpiece in place.
Position the workpiece clamp in such a
way that the sawing movement cannot be
hindered.
Lock button (fig. A2)
In order to protect the saw blade during transport,
the head can be pressed down until it is locked.
• Pull out the lock button (6), then turn it 90° to the
left or right in order to raise and lock the head.
Switching the saw on (fig. A1 + A3)
• Press the switch blocking button (34) to the left
and press the on/off switch (22).
• Let go of the on/off switch to turn the saw off.
Using the laser (fig. A1)
• Activate the laser (1) using the on/off switch (2).
ENGLISH
13