Electrical Safety - Hyundai 56255 Bedienungsanleitung

HYUNDAI
RADIAL MITRE SAW WITH
LASER
56255
WARNING
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for
future reference.
The following symbols are used throughout this
manual:
Denotes risk of personal injury or
damage to the machine.
Important information about the use of
the machine.
Laser beam warning.
Laser beam characteristics.
ADDITIONAL SAFETY INSTRUCTIONS FOR
CUT-OFF MACHINES
• Make sure that all devices screening the saw
blade are in perfect working order.
• Make sure that the saw blade is screened
correctly.
• Never block the saw blade guard. Repair a
jammed saw blade guard before using the
machine again.
• Do not use saw blades made of HSS steel.
• Do not use bent, deformed or otherwise
damaged saw blades.
• Do not use saw blades which do not meet the
specifications stated in this manual.
• Before sawing, remove all nails and other metal
objects from the workpiece.
• Never start sawing before the saw reaches its
full speed.
• Securely clamp the workpiece. Never attempt to
saw extremely small workpieces.
• Only leave the machine after switching off and
when the saw blade has come to a complete
standstill.
• Push the head down and press the head lock
12
when the machine is not in use.
• Never try to slow the saw blade down by
exerting pressure on the side.
• Before performing maintenance to the machine,
always unplug the machine.
Personal safety
Wear safety glasses.
Wear ear protection.
Wear a dust mask
Wear work gloves.

ELECTRICAL SAFETY

Always check that the power supply
corresponds to the voltage on the rating
plate.
ADDITIONAL SAFETY INSTRUCTIONS
FOR LASERS
• Warning! The laser beam potentially causes
severe eye damage. Never look or stare directly
into the laser beam.
• During use, do not point the laser beam at
people, directly or indirectly through reflecting
surfaces.
• This laser complies with class 2 according to EN
60825-1/A11, 1996. The unit includes no
servicing components. Do not open the housing
for any reason. If the unit is damaged, have the
damage repaired by an authorized repair agent.
Using the laser
The laser beam is used for projection of
the cut on the workpiece.
• Switch the laser on by means of the on/off
switch.
• Lower the head while the machine is switched off.
• Check that the laser line aligns with the cutting
line as marked on the workpiece.
• Raise the head and switch on the machine.
• After use, switch off the laser.