Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Function and features
In conjunction with a prismatic reflector or reflective tape the retro-
reflective sensor detects objects and materials without contact and
indicates their presence by a switched signal.
Range (r): see type label (value referred to prismatic reflector with
∅ 80mm).
The highly focussed units detect very small objects. Therefore you must
use a suitable prismatic reflector (e. g. E20722).
Laser radiation; laser protection class 2.
Do not look directly into the beam!
The enclosed labels (warning laser) must be applied in
close proximity to the unit.
Electrical connection
Isolate power, then connect the unit (see page 17 or type label).
Core colours: BN = brown, BU = blue, BK = black.
Programming of the output function by wiring (see page 17 or type
label).
Load of the function check output (fc output): max. 10mA.
Installation and alignment
LEDs red, yellow, green
Fix prismatic reflector / reflective tape in desired position. Align the
photocell towards the reflector; the light spot must hit the prismatic
reflector.
Maximum range is only possible with precise alignment.
Attention: Do not align the beam towards the fixing screw of the pris-
matic reflector.
setting button
7
Werbung
Inhaltsverzeichnis
