Display And Buttons; Display; Buttons - Carrier Rg10A2/Bgef Benutzerhandbuch

2. DISPLAY AND BUTTONS

2.1 DISPLAY

Information are displayed when the remote controller is powered up.
Not applicable for this unit
Breeze away feature display
Not applicable for this unit
Not applicable for this unit
Not applicable for this unit
Transmission Indicator
Lights up when remote
sends signal to indoor
unit
TIMER ON display
TIMER OFF display
Silence feature
display
FAN SPEED display
Displays selected fan speed.
This fan speed can not be
adjusted in AUTO or DRY
mode.
    
Horizontal louver swing
display(some units)
Vertical louver auto
swing display
Note:
All indicators shown in the figure are for the purpose of clear presentation. But during the actaul
operation, only the relative function signs are shown on the display window.
03
Active clean feature display
Fresh feature display
Sleep mode display
Follow me feature display
Wireless control feature display
(some units)
Low battery detection display(If flashes)
MODE display
Displays the current mode,
including:
ECO display
Displays when ECO
feature is activated
GEAR display
Displays when GEAR feature
is activated
LOCK display
Displays when LOCK feature
is activated.
Temperature/Timer/Fan speed
display
Displays the set temperature
by default, or fan speed or
timer setting when using
TIMER ON/OFF functions.
Temperature range:
TURBO mode display 16-30 C /60-86 F or o
o
20-28 C /68-82 F o o (Model dependent)
Not applicalbe for
Fan speed setting range:
this unit
(Model dependent)
AU -100%
Timer setting range:
0-24 hours
This display is blank when
operating in FAN mode.

2.2 BUTTONS

Mode
Press the mode button to
switch the mode in turn.
NOTE: HEAT mode is not supported
by the cooling only appliance.
On/Off
Press to start operation.
Press again to stop.
Temperature UP
Increases temperature in
1 C /1 F increments.
Max. Temp. is 30 C/86 F .
SET
Scrolls through operation
functions as follows:
Fresh( ) Sleep( ) 

Follow Me( )

AP mode( ) Fresh....

The selected symbol will flash on
the display area, press the OK
button to confirm.
OK
Used to confirm the selected
functions.
Fan Speed
Press to select the desired fan speed.
1%
Silence
2%-20%
LOW
21%-40%
41%-60%
MED
61%-80%
Turbo
HIGH
81%-100%
Enables unit to reach preset
AUTO
temperature in shortest possible
time.
MODEL:
RG10A2(U2S)/BGEF
RG10A10(U2S)/BGEF(20-28 C/68-82 F)
ECO Gear
Press to enter the energy
efficient mode.
TIMER
Set timer to turn unit on or off.
Temperature Down
Decreases temperature in 1 C/1 F
increments. Min. Temp. is 16 C/60 F.
NOTE: Press together
&
buttons at the same time for 3 seconds
will alternate the temperature display
between the °C & °F.
Breeze Away
Press to avoid the direct air flow
blowing on the body.
NTOE: This feature is available
under cool, Fan and Dry mode only.
Swing
Starts and stops the horizontal louver
movement. Hold down for 2 seconds
to initiate vertical louver auto swing
feature(some units).
Clean
Used to start/stop the Active Clean
function.
LED
Press to turn on/off the LED
display. Pressing 5 more
seconds to alternate the indoor
display between setting
temperature and room
temperature(Model dependent).
LOCK
Press together Clean button and
Turbo button at the same time more
than 5 seconds to activate Lock
function.
04