Zanussi ZCAN26EW1 Benutzerinformation Seite 61

Problem
The appliance is noisy.
Temperature indicator flashes
from left to right.
The lid does not close com-
pletely.
The lid is difficult to open.
The lamp does not work.
The compressor operates con-
tinually.
There is too much frost and ice.
Possible cause
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
The appliance touches the wall
or other objects.
Temperature sensor error.
Food packages are blocking
the lid.
There is too much frost in the
appliance.
The lid gasket is dirty or sticky.
The lamp is defective.
Temperature is set incorrectly.
Large quantities of food to be
frozen were inserted at the
same time.
The room temperature is too
high.
Food placed in the appliance
was too warm.
The lid is not closed properly.
The SUPER function is switch-
ed on.
The lid is not closed properly or
the gasket is deformed or dirty.
Solution
Check if the appliance is plug-
ged correctly.
Connect the appliance to a
different electrical mains sock-
et. Contact a qualified electri-
cian.
Check if the appliance stands
stable. Refer to "Location"
section.
Slightly move the appliance.
Refer to "Location" section.
Contact the Authorised Serv-
ice Center.
Arrange the packages in the
right way.
Defrost the appliance. Refer to
"Defrosting the freezer" sec-
tion.
Clean the lid gasket.
Contact the Authorised Serv-
ice Center to replace the LED
light.
Refer to "Temperature regula-
tion" section.
Wait a few hours and then
check the temperature again.
Refer to the climate class chart
on the rating plate or to the
"Positioning" section.
Allow food to cool to room
temperature before storing.
Check if the lid closes properly
and the gaskets are not dam-
aged or dirty.
Refer to "SUPER function"
section.
Check if the lid closes proper-
ly. Clean the gasket or replace
it in case of any damage.
61