Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Check the condition of the engine oil and fuel
Engine maintenance
The spark plug should undergo a technical inspection after every 50 hours
of operation. Check the colour of the deposit at the end of the spark plug.
The colour should be brown. Remove the residue using a hard brush. Check
the distance between the electrodes and adjust it if necessary. The correct
distance is 0.7 to 0.8 mm.
Replacing the engine oil
Place the machine on a flat surface, switch it on and warm up the engine
for a few minutes. Unscrew the oil tank cap.
Unscrew the oil tank cap. Place a container to collect the waste oil
underneath the engine. Remove the oil drain screw and drain all the oil. To
protect against oil dripping into the frame of the machine, it is
recommended to use a pipe to bring the oil directly into the waste oil
container.
Check the drain screw, gasket, oil plug and ring. If these parts are damaged
or worn, they must be replaced. Replace and tighten the drain screw. After
this operation, add fresh oil to the upper level on the dipstick.
Air filter
The air filter should be inspected for technical condition. It should be
unscrewed and cleaned or replaced with a new one. The filter should be
washed with water and a mild detergent, dried and replaced. Do not start
the engine with the air filter disassembled.
DISPOSING OF USED DEVICES
Do not dispose of this device in municipal waste systems. Hand it over to an
electric and electrical device recycling and collection point. Check the symbol on
the product, instruction manual and packaging. The plastics used to construct the
device can be recycled in accordance with their markings. By choosing to recycle
you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
Assembly drawings
Werbung
Inhaltsverzeichnis
