Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
handle at all times when the machine is running, otherwise the engine will
stop.
9. Move the choke lever [C] to RUN.
The next step causes the cutting disc to rotate. Make sure that
bystanders are at a safe distance.
10. Move the throttle lever [1] to FAST. If the engine is cold, allow the
engine to idle (throttle lever in SLOW) for a few minutes before starting to
cut.
Removing the stump
• Remove all loose pieces of wood, stones, wire, and other debris from the
area before you start removing the stump.
• Take into account the direction of the wind, as it influences the
displacement of dust and chips.
• Never use the machine in the dark. Sufficient light must be available for
the operator to use the machine safely.
• Always allow the engine to warm up before starting to cut.
• Only part of the saw blade, within 80° of its circumference, may come
into contact with the stump. Never cut using the bottom part of the cutting
disc.
• Never leave the machine unattended while the cutting disc is rotating.
Werbung
Inhaltsverzeichnis
