Maintenance And Adjustments - KingSmith WalkingPad WPS1F Benutzerhandbuch

Maintenance and adjustments

1. Clean the walking machine
2. Adjust the belt
3. Lubricate the belt
Turn off the machine and unplug the
•
power cord.
Add several drops of detergent on cotton
•
rag or towel. Don't pout the detergent on
the belt directly, and don't use acid or
corrosive cleaners.
After using for a period, dust and stains
may appear on the back part, that is
normal situation, then just clean them up.
Press and hold both mode switch button
•
and acceleration button on the remote
control over 3 seconds.
Front panel shows "CALI", and the speed is
•
4 km/hr (2.5 mi/hr).
If belt deviates to the left: Turn the left
•
adjusting screw for a half-circle clockwise.
If belt deviates to the right: Turn the right
•
adjusting screw for a half-circle clockwise.
If belt is slipping: Turn both left and right
•
adjusting screw for a half-circle clockwise
at same time.
Keep the machine running for 1-2 minutes
•
and check whether it needs to readjust.
Turn off the machine and unplug the
•
power cord.
Lift the belt and apply silicone oil on the
•
backside of the belt.
Turn on the machine again.
•
Keep the machine running under 4 km/hr
•
(2.5 mi/hr) for 10-20 seconds.
Only apply 5-10 ml lubricant oil each time,
•
too much lubricant oil makes the belt
become slipping.
Apply for silicone oil once every 3 months.
•
19