Konig Electronic SEC-UNIT50 Installationsanleitung Seite 5

BRACK40) which can be mounted at the bottom of the monitor and fitted with 3 screws on a
horizontal or vertical surface.
8. Connect the camera with the AV-input cable to one of the AV input jack connections on the rear of
the monitor (max. 4 cameras).
9. Insert the DC plug into the monitor's DC 12V input jack connector (12).
10. Insert the AC/DC adapter into the wall socket.
11. You can connect an extra monitor to the AV output connection (13).
User instructions
1. LCD monitor
2. Mute button
3. AV button
4. 4:3 button
5. IR control sensor
1. Press the Power button (9) to switch on the monitor.
2. Press the AV button (3) to set the correct camera connection.
3. Press the Menu button (7) to navigate to the sub-menus.
The following sub-menus are displayed:
• Display settings: "Bright", "Contrast", "Colour" or "Hue"
Adjust the display settings with the + (8) or – (6) button.
• "AV switched set"
Select the cameras, which will be shown subsequently in automatic mode. Press the + or –
button to switch between cameras and the Menu button to select or deselect a camera.
"√" indicates that this camera has been selected.
"ο" indicates that this camera has not been selected.
• "Time switched"
Increase or decrease the time interval for automatic mode with the + or – button.
4. Set the Auto/Manual switch (10) to "auto" to switch between the selected cameras automatically.
When pressing the AV button, manual switching mode shows all camera images,
including cameras, set to "ο".
5. Press the 4:3 button (4) to change the aspect ratio.
6. Press the Mute button (2) to switch the sound off or on.
6. - button
7. Menu button
8. + button
9. Power button
10. Auto/Manual switch
5