Features - Hitech RDX 2 PRO Bedienungsanleitung

Features

Battery Memory (Data Store/Load):
The RDX2 Pro can store up to 10 different charge profiles per port for your convenience. Users can keep
the data pertaining to any program setting for any battery to facilitate seamless charging or discharging.
Saved profiles can be accessed and recalled, as necessary.
Terminal Voltage Control (TVC):
For experienced users ONLY, the charger's end voltage can be reset up to 0.05v/cell higher.
Default setting is recommended. ONLY change in a controlled environment.
ALWAYS monitor the battery during the charge process.
Warning
Twin-Channel Charger:
Hitec's RDX2 Pro allows you to plug two batteries into the charger simultaneously. The batteries being
charged do not need to have the same configuration. You can connect different battery chemistries (NiMH/
NiCd/LiPo/LiFe/Lilo/LiHV/Pb) into any of the charging ports.
Internal Independent Lithium Battery Balancer:
The RDX2 Pro employs an individual-cell-voltage balancer. It is not necessary to connect an external
balancer for balance charging.
Independent Cell Balancing While Discharging:
During the discharge process, the RDX2 Pro can monitor and balance each cell of the battery individually. If
the voltage of any single cell reads abnormally, an error message will display and end the process automa-
tically.
Adaptable to Various Types of Lithium Batteries:
The RDX2 Pro will charge a variety of Lithium batteries such as LiPo, LiFe, LiIo and the new higher
voltage LiHV batteries.
Multiple Lithium Battery Charge Modes:
Balance Charge:
In this mode, each cell is monitored and if some are at higher voltages than the others, they are
discharged to equalize the voltage between all the cells and keep the pack in optimum condition. We highly
recommend using Balance Charge as it is the safest and best way to charge Lithium batteries.
Charge:
This mode charges the pack without balancing the cells. Connecting the balance lead is still recommended
so you can monitor each cells voltage manually by scrolling to the left with the Jog Dial. Note: If the cells are
more than 0.02v off from each other, Balance Charge should be used to equalize the pack.
Fast Charge:
This mode reduces the charge time by approximately 25% as the charge process stops after the terminal
voltage is reached. This will provide about 85% -90% of the rated capacity.
Storage:
This mode charges or discharges the pack to 50% capacity so that it can be safely stored when not in
normal use. If you do NOT plan on using your Lithium pack within 24-48 hours of being fully charged or fully
discharged, Storage Mode is recommended to optimize maximum lifespan and performance and reduce the
risk of the gasses forming, causing the pack to puff.
9