Ufesa PV2600 GLIDEPRO Bedienungsanleitung Seite 20

SPRAYING
This can be used to remove stubborn wrinkles.
As long as there is enough water in the water tank, you may use the spray button at any temperature
setting during steam or dry ironing.
Press the spray button (1) several times to activate the pump while you are ironing.
Do not use the spray function with silk!
STEAM IRONING
- Set the temperature control (7) to the desired position in accordance with the manufacturer's label. The
pilot light (10) will turn on until the temperature is reached. Then the pilot light will turn o .
- Set the variable steam regulator (3) to the desired position.
Temperature control (7) Recommended position of the steam regulator (3)
MIN
/ MAX
CAUTION: Avoid coming in contact with ejected steam.
DRY IRONING
The steam iron can be used on the dry setting with or without water in the water tank,.
- Turn the steam regulator (3) to the minimum position.
- Select the setting on the temperature control (7) best suited for the fabric to be ironed.
SHOT OF STEAM
The shot of steam feature provides additional steam for removing stubborn wrinkles.
- Set the temperature control (7) to "MAX".
- Press the shot of steam button (2) to release the burst of steam.
NOTE: To prevent water leakage from the soleplate, do not keep the steam button pressed for more
than 5 seconds.
VERTICAL IRONING
This can be used to remove creases from hanging clothes, curtains etc.
- Hang article of clothing on a clothes hanger.
- Set the temperature control (7) to "MAX".
- Operate the iron in a vertical position at a distance of 10 cm / 4 in, and press the shot of steam
button (2) repeatedly with pauses of at least 5 seconds.
NOTE: To prevent water leakage from the soleplate, do not keep the steam button pressed for more
than 5 seconds.
20