Safety Instructions - HOMCOM 820-246V70 Montageanleitung

SAFETY INSTRUCTIONS

When using any electrically powered product, basic safety precautions should
always be followed, including the following:
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT.
WARNING - to reduce the risk of fire, electrical shock or injury to persons or property:
1. Always operate the product from a power source of the same voltage, frequency
and rating as indicated on the product identification plate.
2. Remove the unit from its packaging and check to make sure it is in good condition
before using.
3. Do not let children play with parts of the packing ( such as plastic bags)
4. Close supervision is necessary when the product is used by or near children or
infirm persons. Do not allow children to use it as a toy.
5. Do not operate any product with a damaged cord or plug, or after the product
malfunctions, or is dropped or appears damaged in any way. Return the complete
product to the place of purchase for inspection, repair or replacement.
6. Before unplugging the power cord, be sure to turn the power off. When touching
the unit, be sure your hands are dry to prevent electrical shock.
8. Ensure the cord is fully extended before use and arrange it so that it is not in
contact with any part of the heater.
9. In use, some parts of the heater are hot. When moving, hold the heater only by
the handle provided.
10. Do not use the heater in areas such as garages where petrol, paint or other
flammable substances are used or stored.
11. Do not use near or point the heater to furniture, animals, curtains or other
inflammable objects. Keep combustible materials such as furniture, bedding and
any other combustible materials at least 1 metre from the front and sides, and
from the rear of the heater.
12. Do not place the cord under carpet or cover with throw rugs or furniture. Arrange
the cord so that it cannot be tripped over.
13. Do not place the heater on bedding or on thick and long pile carpet where the
openings may be blocked.
14. To reduce the risk of electric shock, do not immerse or expose the product or
flexible cord to rain, moisture or any liquid other than those necessary for correct
operation of the product.
15. This product should not be used in the immediate vicinity of water, such as
bathtub, washbowls, bathroom swimming pool etc. where the likelihood of
immersion or splashing could occur.
16. Switch off and unplug from outlet when not in use, before assembling or
disassembling parts and before cleaning. Remove by grasping the plug - do not
pull on the cord.
17. A common cause of overheating is deposits of dust and fluff entering the heater.
Ensure these deposits are removed regularly by unplugging the heater, allowing
it to cool and cleaning as described in the Care, Cleaning and Storage section.
18. Be sure that no other high current appliances are plugged into the same circuit
with your heater as an overload can occur.
19. Avoid the use of an extension cord as the extension cord may overheat and cause
a risk of fire.
20. Do not use the appliance for other than its intended use.
21. Do not use outdoors. FOR INDOOR USE ONLY.
22. Do not leave the appliance unattended when switched on.
23. Do not place objects on the product or allow objects to obstruct the inlet or outlet
openings, or operate in close proximity to walls or curtains, etc. Do not cover the
unit when in operation.
24. Do not locate the heater immediately below a socket-outlet.
2
EN