Care And Maintenance - ubbink SOLARMAX 2500 Bedienungsanleitung

1
Operating Manual – SolarMax 2500

Care and maintenance

Solar module
Dust, dirt and leaf deposits can build up on the solar module. You can remove these with a microfibre cloth and glass cleaner.
Solar pump
Should the pump start to lose pumping capacity or after a period of time stop working, then please clean the pump as follows..
1) Disconnect the pump cable from the solar module.
2) Unlock the top and bottom parts of the pump housing by pressing the clasps on the two opposite sides of the housing and then lift off the top part of the housing (see Figs. 1 and 2)
3) Take out the pump and open the rotor cover by turning it anticlockwise (see Fig. 3)
4) Pull out the rotor from the rotor bay (see Fig. 4)
6) Clean and wash the individual components.
7) Reassemble the pump in reverse order
Caution! During cleaning, please be careful not to damage the ceramic shaft. It can be easily broken.
Protect the pump from frost!
The pump should not be operated during the cold winter months. Clean the pump with warm water and store the whole system in a frost-free place.
TROUBLESHOOTING
Problem
The pump is not running
The pump is running but no water is coming out
2
Warranty
We offer a warranty of two years on workmanship and materials from the date of purchase. To make a claim on the warranty, the original sales receipt must be enclosed. Warranty
repairs may only be carried out by an authorised customer service provider. This warranty does not cover: ordinary wear and tear, alterations, reworking, damage due to negligence,
third parties and applications for which the product has not been designed, partially or completely disassembled products.
Environmental protection:
Old electrical equipment should not be disposed of with the household waste. Take the old device to your local collection point. Further information can be obtained
from your equipment dealer or waste disposal company.
Declaration of Conformity
The undersigned company UBBINK GARDEN BV declares on it own responsibility that the device SolarMax 2500 satisfies the requirements of the European Directive 2014/30/EU
(Electromagnetic Compatibility). The following harmonised standards were applied:
EN 61000-6-3:2007+A1:2011
EN 61000-3-2:2014
EN 61000-3-3:2013
EN 61000-6-1:2007
Possible cause
The solar module is not connected
The impeller is stuck
The dry running protection has activated
The pump outlet or fountain jet is blocked
4
Remedy
Check the electrical connection between the pump and
the solar module.
Clean the pump as described under "Cleaning and
maintenance"
Make sure the pump is fully submerged in water.
Clean the pump outlet, riser pipes and fountain jet.