Connecting The Power - Dymo Rhino 6000+ Erste Schritte

About Your New Label Printer
For complete information on using your label printer, download the
Rhino 6000 + User Guide from support.dymo.com.
Registering Your Label Printer
Visit www.dymo.com/register to register your label printer online. During the
registration process, you will need the serial number, which is located inside
the label compartment cover.

Connecting the power

To charge the battery the first time you use the printer, insert the battery and plug in the power
adapter. Charging the battery the first time takes approximately 8 hours. Recharging the
battery will take approximately 3.5 hours.
To insert the battery
1 Remove the battery compartment cover.
2 Insert the battery into the battery compartment.
3 Replace the battery compartment cover.
Make sure to read the LiPO Safety Precautions
found on page 3.
The label printer can operate using the rechargeable
battery or the AC power adapter.
1
EN
EN
Download User
Guide