Connecting The Power; Inserting The Battery; Removing The Battery - Dymo LabelManager 280 Anleitung Für Den Schnelleinstieg

Connecting the Power

The label maker is powered by a rechargeable, lithium-ion (Li-ion) battery pack.

Inserting the Battery

The battery pack included with your label maker comes partially charged.
Make sure the charging adapter is disconnected before handling the
Li-ion battery pack.
To insert the battery
Slide the battery compartment cover
1
away from the label maker. See
Figure 1.
Insert the battery into the battery
2
compartment as shown in Figure 1.
Replace the battery cover.
3
Make sure to read the Li-ion Safety
Precautions found on page 8.

Removing the Battery

Remove the battery pack if the label maker will not be used for a long period
of time.
Make sure the charging adapter is disconnected before handling the
Li-ion battery pack.
To remove the battery
Unplug the charging adapter.
1
Slide the battery compartment cover away from the label maker.
2
See Figure 1.
Remove the battery from the battery compartment.
3
Make sure to read the Li-ion Safety Precautions found on page 8.
2
Figure 1