Maintenance - DeWalt DWC410 Handbuch

EN GLI SH
Depth of Cut Adjustment (fi g. 5)
1. Loosen the depth adjustment knob (m) to
release.
2. Move the shoe (n) up or down to desired
position.
3. Tighten the depth adjustment knob.
Wet Cut method (Fig. 1)
WARNING: Do not use wet cut system
unless tool is protected by the PRCD.
WARNING: To reduce the risk of
electric shock, ensure water will not
enter into your tool. Do not touch plug
with wet hands.
1. Follow the instructions described under
Mounting the Wet Cut System.
2. To regulate the water flow, open the water valve
by pivoting the lever (o) away from the unit.
3. To close water valve, push the lever toward the
unit.
Proceed as described below for straight or angled
cuts.
Straight cuts (Fig. 1)
1. Using a marker or grease pencil, mark the area
to be cut.
2. Place the shoe (n) of the saw on the workpiece
ensuring that the blade does not touch the
workpiece.
3. Align the external part of the cutting guide (p)
with the cut outline on the workpiece.
4. Turn the tool on and wait for the blade to reach
its maximum velocity.
5. Move the tool slowly and evenly forward,
following the cut line.
Angled cuts (Fig. 1, 6)
1. Using a marker or grease pencil, mark the area
to be cut.
2. Release the bevel adjustment knob (q) and
move it to the desired angle.
3. After selecting the desired angle, tighten the
bevel adjustment knob to secure the shoe.
4. Align the internal part of the cutting guide (p)
with the cut line on the workpiece.
5. Turn the tool on and wait for the blade to reach
its maximum velocity.
6. Move the tool slowly and evenly forward,
following the cut line.
32

MAINTENANCE

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
WARNING: This is a non user
maintenance tool. It has to be
maintained by an official D
maintainance dealer only.
Lubrication
WARNING: NEVER
spray or in any
other way apply
lubricants or
cleaning solvents
inside the tool.
This may result in personal injury
and can seriously affect the life and
performance of the tool.
D WALT tools are properly lubricated at the factory
E
and are ready for use. However, it is recommended
that, once a year, you take or send the tool to a
certified service center for a thorough cleaning and
inspection.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
WALT
E