Time/Date; Auto Update (Time/Date); Network Wizard (Internet Connection); Wps Connection - Hama IR110 Bedienungsanleitung

5.2.2.1 Time/Date

Use this menu item to choose whether the radio should
display the current time using the 12 or 24 hour clock.
Confirm your selection by pressing the [ENTER] button.
Alternative access method:
[MENU] > System settings > Time/Date

5.2.2.2 Auto update (time/date)

Use this menu item to determine whether the time and
date should be updated via a receiver technology (internet)
or if the time should be set manually. Confirm the selection
using [ENTER]. If the current time is to be sourced from
the internet, you must then select the time zone in which
you are currently located. If your time zone differentiates
between summer time and winter time, activate/deactivate
the ‚Daylight savings' function.
If you should use manual setting, you can change each part
of the date and time by turning the navigation controller,
and then confirm your changes by pressing the [ENTER]
button.
Alternative access method:
[MENU] > System settings > Time/Date > Auto update
[MENU] > System settings > Time/Date > Set Time/Date
[MENU] > System settings > Time/Date > Set format
Note
• When using automatic update (via NET) you also have
the option later in Time settings of accessing the time
zone and summer time setting.
[MENU] > System settings > Time/Date > Set timezone
[MENU] > System settings > Time/Date > Daylight savings
12

5.2.2.3 Network wizard (internet connection)

The radio automatically looks for available WLAN networks.
Once the radio has finished its search, you will be presented
with an overview of available networks, and you will be
able to configure a cable-based network or manually set up
the Internet connection.
Alternative access method:
[MENU] > System settings > Network > Network wizard
If the radio should not detect your network, you can
perform another scan by selecting [Rescan] and pressing
[ENTER]. If your network is still not detected, you can try to
configure the connection manually (5.2.2.3.5).
WLAN connection

5.2.2.3.1 WPS connection

Devices that support connection via WPS (Wi-Fi Protected
Setup) are identified in the list as [WPS]. If you wish to
establish a connection via WPS, press [ENTER] after you
have selected the desired SSID (Service Set Identifier – ID
for network). The radio then offers the option to initiate
WPS by pushing the button or using a PIN. With the ‚Push
Button' function you must start the WPS scan on the
remote station (e.g. router). Consult the manual for your
router or Access Points (AP) to learn how to do this. After
you have done this, press [ENTER] on the radio and both
devices will establish a connection.
With the PIN method the radio creates an 8-digit number,
which you then have to enter into the remote station.
After entering the PIN, press the [ENTER] button again to
establish the connection between both devices.
Alternative access method:
[MENU] > System settings > Network > PBC Wlan setup
PBC = Push Button Configuration