Werbung
locomotive. Push down the front
plow to plow the rails and lift up
the rear plow to expose the coup-
ler. Now you can clear light snow
on your garden railway.
Attention: Avoid connecting this
model with locos with different
starting characteristics. This can
damage the internal gearing. To
find out whether the snowplow
and a loco are compatible, place
them on the rails a foot apart.
Operate the throttle and see
whether their starting voltage and
speeds are similar.
Multi-Train System
This model is not designed for
installation
of
System decoder. To use this
model on a Multi-Train System
layout, use the Analog Control
(„7+1") option or contact an LGB
service station (see Factory Ser-
vice).
Power Supply
Attention! For safety and reliabi-
lity, operate this model with LGB
power supplies (transformers,
power packs and controls) only.
The use of non-LGB power sup-
plies may void your warranty.
When this model is used with a
second locomotive to clear snow,
the power requirements can
increase significantly. Be sure to
use an adequate power supply.
For more information on LGB
power supplies for indoor, outdoor
and multi-train operation, see the
LGB catalog.
Attention! After extended opera-
tion, this model may leave a small
amount of carbon dust around the
track. This dust can stain carpet
and other materials. The user
assumes full responsibility for any
damage.
MAINTENANCE
Attention! Improper service may
void your warranty. For factory
authorized service, contact an
authorized retailer or send this
product to an LGB service station
(see Factory Service).
Cleaning
This model can be cleaned using
a mild detergent and gentle stre-
am of water. Do not immerse this
model.
Replacing the traction tire
- Use a small, straight-blade scr-
ewdriver to gently pry the old
traction tire out of the wheel
a
Multi-Train
groove.
- Gently warm the new traction
tire in a dish of warm water.
- Use a small, straight-blade scr-
ewdriver to gently pry the new
traction tire into the wheel groo-
ve.
- Make sure that the traction tire is
completely in the wheel groove.
Replacing the motor
- Remove the two screws on top
of the gearbox.
- Take off both gearbox covers.
- Replace the motor.
- Reassemble.
Attention! If the motor is repla-
ced, generously lubricate the
gears with LGB Gear Lubricant
(51020).
Replacing the loco brushes,
pick-up shoes and wheelsets
Remove the the four screws on
the bottom gearbox plate, and
remove the plate. Replace the
necessary parts. Reassemble.
Attention! If the wheelsets are
replaced, generously lubricate
the gears with LGB Gear Lubri-
cant (51020).
Maintenance parts
50020 Special Tool Set
51020 Gear Lubricant
62201 Standard Motor
63120 Brushes, 14mm, 16mm,
8 pieces
63218 Standard Pick-Up Shoes,
2 pieces
69104 Traction Tire, 37.5mm,
10 pieces
FACTORY SERVICE
For factory authorized service,
contact an authorized retailer or
send this product to one of the
LGB service stations listed below:
Ernst Paul Lehmann Patentwerk
Reparatur-Abteilung
Saganer Strasse 1-5
D-90475 Nürnberg
GERMANY
Telephone: (0911) 83707 0
LGB of America
6444 Nancy Ridge Drive
San Diego, CA 92121
USA
Telephone: (619) 535-9387
You are responsible for any ship-
ping
costs,
customs fees.
CAUTION! This model is not for
children under 8 years of age.
This model has small parts, sharp
parts and moving parts. Save the
insurance
and
5
Werbung
