Construction; Safety Information - Scheppach CID180-20Li Original Bedienungsanleitung

• If possible, store the packaging until the warranty
period has expired.
• Familiarize yourself with the machine with the help
of the operating instructions manual before using
it.
• Use only original parts for accessories as well as
consumables and spare parts. Spare parts can be
obtained from your scheppach retailer.
• Please quote our article numbers as well as type
and production year in all your orders.
m ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, film and small parts! There is a risk of
swallowing and suffocation!

6. Construction

Warning!
Always remove the battery pack before making
adjustments to the equipment.
Be sure to read the following information before you
put the cordless equipment into operation:

7. Safety information

m WARNING Read all safety warnings and all in-
structions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Workplace safety
a) Keep your working area clean and well lit. Untidy or
poorly lit working areas can lead to accidents.
b) Do not work with the device in potentially explosive
environments in which there are inflammable liquids,
gases or dusts. Electrical power tools create sparks,
which can ignite dusts or fumes.
c) Keep children and other people away while you are
operating the electrical tool. Distractions can cause
you to lose control of the device.
2. Electrical safety
a) The mains plug on the device must match the
mains socket. The plug must not be modified in any
way. Do not use
plugs and matching sockets reduce the risk of electric
shock.
b) Avoid touching earthed surfaces such as pipes, ra-
diators, ovens and refrigerators with any part of your
body.
There is an increased risk of electric shock if your
body is earthed.
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
c) Keep the device away from rain or moisture. Wa-
ter entering an electrical device increases the risk of
electric shock.
d) Do not use the mains lead for any purpose for
which it was not intended, e.g. to carry the device,
to hang up the device or to pull the mains plug out
of the mains socket. Keep the mains lead away from
heat, oil, sharp edges or moving parts of the device.
Damaged or tangled mains leads increase the risk of
electric shock.
e) When working outdoors with an electrical power
tool always use extension cables that are also ap-
proved
for use outdoors. The use of an extension cable suita-
ble for outdoor use reduces the risk of electric shock.
f) Use a residual current device (RCD) for protection
if operating the electrical power tool in a moist envi-
ronment
is unavoidable. The use of an RCD reduces the risk
of electric shock.
3. Personal safety
a) Remain alert at all times, watch what you are do-
ing and always proceed with caution. Do not use the
device if
you are tired or under the influence of drugs, alcohol
or medication. One moment of carelessness when
using the device can lead to serious injury.
b) Wear personal protective equipment and always
wear safety glasses. The wearing of personal protec-
tive equipment such as dust masks, non-slip safety
shoes, safety helmets or ear protectors, appropriate
to the type of electrical power tool used and work un-
dertaken, reduces the risk of injury.
c) Avoid unintentional operation of the device. Check
that the electrical power tool is switched off before
you connect it to the mains, pick it up or carry it. Ac-
cidents can happen if you carry the device with your
finger on the ON / OFF switch or with the device
switched on.
d) Remove any setting tools or spanners before you
switch the device on. A tool or spanner left attached
to a rotating part of a device can lead to injury.
e) Avoid placing your body in an unnatural position.
Keep proper footing and balance at all times. By do-
ing this
you will be in a better position to control the device in
unforeseen circumstances.
f) Wear suitable clothing. Do not wear loose clothing
or jewellery. Keep your hair, clothing and gloves clear
of moving parts. Loose clothing, jewellery or long hair
can become trapped in moving parts.
g) If vacuum dust extraction and collection devices
are fitted do not forget to check that they are properly
connected and correctly used. The use of these de-
vices reduces the hazard presented by dust.
4. Careful handling and use of electrical power tools
19 | GB