Function And Use - Electrolux IH EFC 9780 Montage- Und Gebrauchsanweisung

7 FUNCTION AND USE

7.1 SOFT TOUCH CONTROLS WITH PUSH BUTTONS SCREENPRINTED ON S/STEEL
(FIG.8)
WARNING! To activate the functions connected to these push buttons, it is necessary
to apply a little pressure just lightly and for a short time. If pressure is too lengthy on
the push buttons the connected functions are not activated.
WARNING! The hood is equipped with 2 independent controls each of which activates
an independent motor and 3 lamps.
The functions activated by the push buttons are as follows:
LIGHTS: switch the lights on and off;
O
MOTOR OFF: turn the motor off;
-
reduces the motor speed;
+
increases the motor speed;
TIMER: if pressed when the hood is already functioning with 1st, 2nd, 3rd or 4th
speed, the led point connected with the selected speed, starts to flash for 10
minutes, after which motor automatically stops.
MEANING OF THE LED POINTS: if the leds connected with the speeds are flashing, there is
a timing running.
5th and 6th Speed must be used just for short periods as the hood is taking in a big quantity
of air so after 10 minutes the motor is automatically reset to the 3rd speed.
7.2 AUTOMATIC CONTROL OF GREASE AND CARBON FILTER
the electronic controls with led points allow automatic control of the grease filters and carbon
filters (only in case the hood is used in filtering version) so that the user does not have to
remember when maintenance was last carried out.
above the timer push button keeps on flashing.
(for carbon filters that can be regenerated) an acoustic signal is issued for some seconds and
the led point above the light push button keeps on flashing.
7.3 TO PUT THE GREASE AND CARBON FILTERS CONTROL BACK TO ZERO
To put the grease filter counter back to zero you must:
•
stop the motor;
•
press the timer push button twice in succession, until you hear the acoustic signal.
To confirm reset the led point stops flashing.
To put the carbon filter counter back to zero you must:
•
stop the motor;
•
press the light push button twice in succession until you hear the acoustic signal.
24
1st Speed;
2nd Speed;
3rd Speed;
4th Speed;
5th Speed; led point is flashing;
6th Speed; led point is flashing.
When the grease filters require
cleaning, an acoustic signal is issued
for some seconds and the led point
When the carbon filters need replacing,
(for carbon filters that cannot be
regenerated) and to be regenerated