Troubleshooting - Dometic HC302 Montageanleitung Und Bedienungsanleitung

HC302, HC502
9

Troubleshooting

Water in or under the refrigerator
Fault
Water is leaking into the
inside of the refrigerator.
Water is leaking onto the
floor.
Display signals
Signal
General error
The display blinks each
second.
Sensor failure
The display blinks and
shows "E1".
Low battery
The display blinks and
shows "E2" alternately
with the current temper-
ature.
EN
Possible cause
The condensate drain duct is clogged. Clean the drain.
Medicines are preventing the water
from flowing to the collector.
There is too much water in the water
container.
Explanation
The display shows alternately the current inner temperature and
the active error code (fig. 2 1, page 2) (E1 or E2, see below).
The minimum and maximum values will be kept as the last known
values.
The minimum and maximum inner temperatures are still visible
and will be updated from the current inner temperature reading.
Troubleshooting
Remedy
Make sure that medicines
do not touch the rear wall.
Clean the water container.
21