Leuze electronic BCL 500i Bedienungsanleitung Seite 20

EN
Commissioning
2
Mounting
Mounting through bore holes in the housing for M4 screws or using the BT 56 /
BT 59 mounting system (accessories).
A Optical axis
B Optical swivel range:
NOTE
Protection class IP 65 is achieved only if the connectors and caps are screwed
into place!
3
Electrical connection – Commissioning with factory settings
 Connect voltage supply and, if necessary, switching input, USB service inter-
face and host/bus interface.
 Switch on operating voltage, LED PWR must illuminate green.
 Activate scanner via switching input or with the aid of the key pad / display; the
laser switches on.
 Hold the following "LEUZE" sample bar code up to the BCL 5xxi at a distance
of approx. 500mm.
Upon successful completion of the read operation, the sensor beam switches
off and the read result is shown in the display.
 End the reading gate by removing the switching input signal or with the aid of
the key pad / display.
20
Deflecting mirror version = ± 10°
Oscillating mirror version = ± 20 °